assassin oxp

Alex · Post by **Alex** » Tue Mar 02, 2010 7:03 pm

Hi Commanders,
Was wondering if anyone has an idiots guide on how to reset the Assassin oxp to begining.
I started it early 09 but driffted off and removed the oxp from 'Addon' folder.
Been playing around each G from then, slower.
Now wish to go back to G7 to start the assassin oxp again.
I know in the save file it remembers where I was. But don't remember how I got there.
It was getting a bit too hard with a less than a 'Hard ass' ship.
This time round, think I may be ready?? Flying Caddy with bells and whistles. But would really like to start from scratch.

Commander McLane · Post by **Commander McLane** » Tue Mar 02, 2010 7:39 pm

Just find the mission_variables-dictionary in your save game and delete everything that starts with mission_assassins_

Alex · Post by **Alex** » Tue Mar 02, 2010 7:46 pm

Thanks Cmdr. McLane

Zbond-Zbond · Post by **Zbond-Zbond** » Tue Mar 09, 2010 12:41 am

..what would happen if I deleted the OXP and re-downloaded it, then went to G7 (as the same commander)(i.e. the commander that has already completed the missions)?

I suppose going there as a different commander - one that hadn't joined the Assassins Guild yet - would get the full mission

JensAyton · Post by **JensAyton** » Tue Mar 09, 2010 12:54 am

Zbond-Zbond wrote:
..what would happen if I deleted the OXP and re-downloaded it, then went to G7 (as the same commander)(i.e. the commander that has already completed the missions)?

Exactly the same thing as if you just left the OXP there.

allikat · Post by **allikat** » Tue Mar 09, 2010 1:03 am

Because the commander's variables for the mission are stored in the commander save file. The OXP will normally check/update those at launch or load (depending on the OXP and circumstances)
Thus if you reinstall the OXP, it will still get the same values again when you reload the commander. As Commander McLane says, if you want to reset the OXP (or any other mission, including the built in ones) you should delete the variables in your save file, or paste over the values from a newbie save.