Using Wings 3D to produce models for Oolite

Tricky · Post by **Tricky** » Thu Jun 28, 2012 6:39 pm

Don't laugh...

...and it honestly thinks it's a pirate.

Commander Smivs · Post by **Smivs** » Thu Jun 28, 2012 6:41 pm

Puts a whole new meaning on the phrase 'Dicing with death'!

Tricky · Post by **Tricky** » Thu Jun 28, 2012 8:16 pm

:snickers

This lot are all 400 metres in diameter. Not exactly hard to spot when off scanner.

Getting the hang of this. Now I just need to work how to "put the fluff on" as Griff says.

Commander Smivs · Post by **Smivs** » Thu Jun 28, 2012 9:57 pm

Tricky wrote:

Getting the hang of this. Now I just need to work how to "put the fluff on" as Griff says.

Putting the fluff on those!
Now that would give a whole new meaning to the phrase 'FurBall'.

Tricky · Post by **Tricky** » Thu Jun 28, 2012 11:11 pm

I would say that you're on fire with those comments, however you do have have an advantage with that candle. Just don't be burning it at both ends.

Shipbuilder · Post by **Shipbuilder** » Fri Jun 29, 2012 12:11 pm

Gents – Thanks for the info regarding viewing textured models in Wings 3D. The problem appears to have been the fact that somehow I ‘lost’ my additional material in the outliner box ( i probably deleted it by mistake....

).

I had the png texture and the default material but the additional material was missing.

I have since looked at this with another model where I have the second material in the outliner box and all works fine.

Oolite Bulletins

Using Wings 3D to produce models for Oolite

Re: Using Wings 3D to produce models for Oolite

Re: Using Wings 3D to produce models for Oolite

Re: Using Wings 3D to produce models for Oolite

Re: Using Wings 3D to produce models for Oolite

Re: Using Wings 3D to produce models for Oolite

Re: Using Wings 3D to produce models for Oolite