You know those who, having been mugged and stabbed, fired, dog run over, house burned down, wife eloped with best friend, daughters becoming prostitutes and their countries invaded - still say that "all is well"?
I'm obviously not one of them.
I was trying to follow this tutorial, and got lost fairly early on. I'm with him up to the point where he says
Now I can make the rough shape. I'll do this by moving edges round to match positions on the image of the mini in the image-plane.
To start I'll enter edge mode and select the edges at the front I want and move them using right-click Move -> Y.
My view doesn't look like his figures anymore... In particular, I don't see the horizontal edges across the front of the body: my new edges are segments of the vertical edges the front face of the body. When I do the Move->Y command with a pair of those edges selected the results are difficult to describe. Also I can't get my figure to look like the one right after he says
Then I'll do the same at the rear. Resetting to a normal view this gives me:
Is it possible he does another loop connect command in there someplace?
